Tutorial: 3D Printed Non contact Water Level Alarm with ESP 12F

INTRODUCTION

From flood control to garden care, water level monitoring systems can be of considerable use.🌊🤓 So as our latest #3DPrinting + ESP-12F project, we made this Non-contact Water Level Alarm that can monitor changes in water levels and give alarms without direct contact with the water. Check it now in the video below!

ELECTRONICS USED IN THIS PROJECT

Featured product:

The shell was fully printed on the👉 ELEGOO Mars 2 Pro 3D Printer

ASSEMBLY INSTRUCTION

You can learn how to make this Arduino based gadget step-by-step in the video below:

DOWNLOAD

Download code and schematic of this project here: https://bit.ly/2SKvGvh

And don't forget to share your makings with us on social networks.

 


Leave a comment

Please note, comments must be approved before they are published

Related Articles