Tutorial: Bluetooth Controlled "Do Not Disturb" Notifier with Arduino & 3DPrinting

INTRODUCTION

Tired of being disturbed by your surroundings while working at home? Here we made a Bluetooth-lcontrolled "Do Not Disturb" Notifier to help you stay focused or keep unwanted outside the house. This project is based on an #ArduinoUNO and built with #3DPrinted shell, check out in the video!

ELECTRONICS USED IN THIS PROJECT

Featured product:

Elegoo UNO R3, Elegoo Smart Robot Car V3.0 Expansion Board, Bluetooth Module, Servo Motor in Elegoo Smart Robot Car Kit V3.0 Matrix LED and DuPont Wire in Elegoo UNO R3 Most Complete Starter Kit

ASSEMBLY INSTRUCTION

You can learn how to make this Arduino based gadget step-by-step in the video below:

DOWNLOAD 

Download code and schematic of this project here: https://bit.ly/31ba68l

And don't forget to share your makings with us on social networks.

 


Leave a comment

Please note, comments must be approved before they are published

Related Articles